Ice helps to save electricity for refrigerator

First, try not to open the refrigerator door. Then freeze a large piece of ice in the lower layer of the refrigerator, put it in a fresh-keeping box, and put some water in the box, so that the ice can float without covering. This can reduce the number of refrigerator start-up, naturally save electricity.

In addition, the refrigerator should not be filled with food, but should leave a gap to facilitate the circulation of cold air. In this way, the speed of food cooling is faster, the number of compressor operation is reduced, and electric energy is saved. When fresh fruits and vegetables are put into the refrigerator, they must be spread out. If fruits and vegetables are piled together, it will cause external cooling and internal heat, which will consume more electricity; hot food can be put into the refrigerator after cooling; food that needs to be thawed can be taken from the freezer to the micro freezer several hours in advance, because the cold air of frozen food can help maintain the temperature and reduce the operation of the compressor, so as to achieve the purpose of saving electricity; making ice and cold drinks should be arranged as late as possible Between.

Because of the low temperature at night, it is conducive to the heat dissipation of the condenser.

In addition, the compressor usually does not open the door to pick up and put food at night, and the working time of the compressor is also short; on the premise of ensuring the quality of food, the temperature controller should be adjusted reasonably according to the seasonal change, the type and quantity of food, so as to make the refrigerator always in the best working state; when the power is off, please reduce the number of opening the door, and try not to put food in as much as possible, so as to reduce the loss of cooling capacity; whenever the ambient temperature is low, the compressor can not open the door When the temperature is higher than 10 ℃ (some are 16 ℃), the winter compensation (power-saving switch) must be turned off to prevent unnecessary consumption due to the increase of start-up time and start-up and stop times; the sealing pad around the box door shall be checked regularly to avoid the leakage of cold air; the manual defrosting refrigerator shall be defrosted when the frost thickness exceeds 0.6cm to ensure the heat absorption and heat dissipation of evaporator and condenser Good performance. Shorten the compressor working time. These small problems as long as a little attention, can help the refrigerator save electricity.